Advertising Disclosure
10 Best esr meter in Canada
Best Choice01VellemanAtlas ESR70
Main highlights- Protected against highly charged capacitors.
- New enhanced dynamic range of 0.00 to 40.0 ohms
- Measure Capacitance and ESR In-Circuit
- ESR Resolution as fine as 0.01 ohms and Capaciatance of 0.2uF!
- Audible alerts for various ESR levels.
9.9Exceptional
Show more
- Curious about how we select the top products for you? Explore How It Works
- 02DER EE
DE-5000 Handheld LCR Meter With TL-21 TL-22 TL-23
9.7Exceptional
- 03FNIRSI
FNIRSI LC1020E 100kHz LCR Meter, Capacitor Tester with ESR, Auto R/L/C Test
Main highlights- 【User-Friendly】ESR meter capacitor tester features 3-pin sockets and 5-slot jacks for precise four-terminal (Kelvin) measurements with professional fixtures. 2.8” TFT display with 10-level brightness. 3000mAh battery with auto-off, Type-C charging/firmware updates
- 【Smart Sorting】ESR Meter with Sorting & Comparison Mode calculates relative error (%) using preset nominal/tolerance (0.1%–99.9%) for accurate component screening. Alerts via sound/LED. Supports Capacitors 1pF–100mF, Resistors 10mΩ–10MΩ, Inductors 1µH–100H
- 【Reliable Testing】Capacitance meter supports open/short calibration, adjustable test voltage (0.1/0.3/0.6V) and internal bias (0.0/0.5V). Records if components meet preset nominal/tolerance, tracking success/fail counts. Data hold locks readings. 100Ω output ensures accuracy. Speed: Fast (4/s), Medium (2/s), Slow (1/s)
- 【Note】Perform open/short calibration before measurement. Fully discharge capacitors and inductors. For onboard components, ensure the circuit is powered off. Do not measure live circuits to avoid damage or inaccurate readings
- 【Dual Parameter】LC1020E LCR Meter supports AUTO, Capacitance, Resistance, and Inductance with main/secondary parameters (X/D/Q/θ/ESR) shown simultaneously. Frequencies: 100Hz/120Hz/1kHz/10kHz/100kHz. 19,999-count display ensures precise readings
9.4Excellent
Show more
- 04Tyenaza
ESR Capacitance Meter, MESR-100 V2 Auto Ranging in Circuit ESR LCR Meter Capacitor/Low Ohm Meter Up to 0.01 to 100R
Main highlights- 【EXCELLENT PERFORMANCE】Dual terminal, for fast and easy inspect general capacitor or resistor, a printed ESR table for fast check.
- 【APPLY TO】Our ESR meter only applies less than 15mV DC or peak to peak on a good capacitor, as a result we can use it as in circuit test. During repairing TV, LCD, Audio board, etc. we can in circuit testing the capacitor is good or not.
- SUITABLE FOR --- During repairing TV, LCD, Audio board, etc. we can in circuit testing the capacitor is good or not.
- SIZE SPECIFICATION --- ESR Capacitance Meter is a series resistor inside capacitor, using 100kHz to remove the impedance 1/(2*pi*F*C).
- ACCURATE MEASUREMENT --- The impedance become small, and we can then measure the true series resistor value.
9.3Excellent
Show more
Value for Money05FNIRSIFNIRSI LCR-P1 Transistor Tester, Mosfet Transistor Capacitor Tester, SMD Electronic Component Tester, Diode Triode Zener Diode Resistance Inductance Battery Test LCR Meter MOS PNP NPN ESR Meter
Main highlights- Transistor Capacitor Tester: FNIRSI LCR-P1 transistor tester can be used for the measurement and analysis of patch component, NPN, PNP, triode, MOS, field effect transistor (FET), diode, Zener diode, capacitor, resistor, inductor, battery, etc
- NEC Infrared Waveform: FNIRSI LCR-P1 transistor detector supports the analysis of NEC infrared protocol code, so it can be used for the debugging and maintenance of remote control equipment, and provides users with comprehensive detection and analysis
- Intelligent automatic identification: Capacer tester intelligent automatic detection of component pins definition and parameters, and can quickly identify its models and specifications, thereby greatly improving the efficiency of work
- Friendly Design: The design of the replaceable patch seat enables measurement of both tiny precision components and high-power devices. 1.44 inch full-color screen, 300 mah battery, Type-c interface for charging and data transmission, firmware upgrade
- Anti-burn protection mechanism: The capacitance resistance esr tester automatically identifies undischarged capacitors and automatically discharges them at the moment of insertion and locking, effectively avoiding accidental burning
9.0Excellent
Show more
- 06Toeasliving
Meter, MESR-100 Capacitance Ohm Meter Professional Measuring Internal Resistance of Capacitor Capacitance Circuit Tester, Capacitance Meter, Circuit Test
Main highlights- Using this theory, we can measure the capacitor is bad/ damaged or good in condition.
- The impedance become small, and we can then measure the true series resistor value.
- Our meter only applies less than 15mV DC or peak to peak on a good capacitor, as a result we can use it as in circuit test.
- It is a series resistor inside capacitor, using 100kHz to remove the impedance 1/(2*pi*F*C).
- During repairing TV, LCD, o board, etc. we can in circuit testing the capacitor is good or not.
8.8Very Good
Show more
- 07GME
GME Professional in-Circuit ESR Capacitor Tester, Capacitance ESR Meter, Designed and Engineered in The USA
11% OffMain highlights- 【WIDE RANGE IN-CIRCUIT ESR & DCR TESTING】 Tester meter measures ESR (equivalent Series Resistance) on capacitors range from 0.47µF to 2200µF, in or out of circuit
- 【INTELLIGENT DESIGN】 ESR capacitor tester automatically discharges capacitor under test; Audible buzzer announces ESR range during testing allows quick checking of entire PCB in seconds; Intelligent automatic calibration on power up, no manual zero needed unlike many other ESR meters
- 【EASY TO USE, PORTABLE, AND RUGGED DESIGN】 Easy One-Handed Tweezers with gold plated tips and extra-long cable; Non polarity dependent test probe, eliminates the need for polarity checking
- 【DESIGNED AND ENGINEERED IN THE USA】 GME Professional in Circuit ESR capacitor tester designed and supported in the USA; compare to most other ESR meters on the market that are generic private label import with unknown manufacturer and no support or warranty
- 【ACCURATE MICROPROCESSOR CONTROLLED】 Microprocessor generated 100 kHz output test frequency and low 15 mVp-p output test voltage that will not turn on any solid state devices during testing, critical for accurate test result in circuitry with active components
8.7Very Good
Show more
- 08FNIRSI
FNIRSI LCR-ST2 100kHz LCR Meter Tweezer SMD & Through-Hole Component Tester
Main highlights- 【Primary/Secondary Display】Auto measurement with primary parameters (R/C/L/Z) and secondary parameters (X/D/Q/θ) for thorough analysis and reliable testing. Ideal for electronics diagnostics and component verification
- 【Precise & Reliable Testing】Four RMS test levels (0.1 / 0.3 / 0.6 / 1.0 V) with series/parallel mode to reduce parasitic effects. Capacitors (1 pF–22 mF), resistors (10 mΩ–10 MΩ), inductors (1 μH–10 H), diodes (≤0.7 V), voltage (±30 V), and continuity
- 【Portable & Complete Kit】Includes Kelvin clips, gold-plated tweezer tips, and hooks. Quick plug-and-swap design lets you switch probes fast for different components. Comes with a storage pouch for easy carry and organization
- 【Easy to Use & Read】Capacitor Tester with left/right-hand mode, 1.47" HD display, and adjustable brightness. Built-in 300 mAh rechargeable battery with Type-C charging and auto power-off. High-strength rear magnet keeps the meter secure and saves workspace
- 【All-in-One】LCR-ST2 LCR Meter for SMD & through-hole parts. Measures resistors, capacitors, inductors, diodes, continuity, voltage. Smart auto sorting identifies abnormal components. 100 Hz/120 Hz/1 kHz/10 kHz/100 kHz full-range scan for RF to large electrolytics
8.4Good
Show more
- 09FNIRSI
FNIRSI LCR-ST2 100kHz LCR ESR Meter Tweezer, SMD Component Tester, Auto Sort Compare, Resistor, Inductor, Diode, Capacitor Tester, Measures Voltage, Continuity, Full-Band Scan, Series/Parallel Mode
Main highlights- 【Primary/Secondary Display】Auto measurement with primary parameters (R/C/L/Z) and secondary parameters (X/D/Q/θ) for thorough analysis and reliable testing. Ideal for electronics diagnostics and component verification
- 【Precise & Reliable Testing】Four RMS test levels (0.1 / 0.3 / 0.6 / 1.0 V) with series/parallel mode to reduce parasitic effects. Capacitors (1 pF–22 mF), resistors (10 mΩ–10 MΩ), inductors (1 μH–10 H), diodes (≤0.7 V), voltage (±30 V), and continuity
- 【Portable & Complete Kit】Excludes Kelvin clips; includes gold-plated straight and angled tweezer tips. Quick plug-and-swap design lets you switch tips fast for different components. Comes with a storage pouch for easy carrying and organization
- 【Easy to Use & Read】Capacitor Tester with left/right-hand mode, 1.47" HD display, and adjustable brightness. Built-in 300 mAh rechargeable battery with Type-C charging and auto power-off. High-strength rear magnet keeps the meter secure and saves workspace
- 【All-in-One】FNIRSI LCR-ST2 LCR Meter for SMD parts. Measures resistors, capacitors, inductors, diodes, continuity, voltage. Smart auto sorting identifies abnormal components. 100 Hz/120 Hz/1 kHz/10 kHz/100 kHz full-range scan for RF to large electrolytics
8.3Good
Show more
- 10FNIRSI
FNIRSI 2C53T 3-in-1 50MHz 2CH Oscilloscope Multimeter DDS Signal Generator
Main highlights- 【Signal Generator】The maximum waveform output frequency can reach 50 kHz and a step of 1 Hz, and can output 13 waveforms
- 【Save function】one-click save, screening function. You can upload the saved image by connecting to PC via Type-C. You can easily compare the waveforms by displaying the reference waveform and the measured waveform on the same screen
- 【Newly Version】The 2C53T is an upgraded version of the 2C23T, which improves the measuring range and adds math operation，cursor measurement，persistence mode，XY mode features
- 【Excellent Design】The Oscilloscope adopts FPGA+MCU+ADC hardware architecture, built-in high-voltage protection module, adopts 2.8 inch LCD display, built-in 3000 mAh Li-ion battery, standby time up to 6 H, Type-C interface supports 5 V/1 A charging
- 【4.5-Digit 19999 Counts Multimeter】AC Voltage: 0-750 V, DC Voltage: 0-999.9 V, DC/AC Current: 0-9.999 A, Resistance: 0-19.99 MΩ, Capacitance: 0-99.99 mF, Continuity Measurement. Multi-function meter for professionals, schools and hobbyists
- 【2 Channel Oscilloscope】50 MHz bandwidth, 250 MSa/s sampling rate, 1 Kpts record depth, automatic measurement function, max voltage 400 V, vertical sensitivity 10mV/div-10V/div , support waveform image storage and export
8.0Good
Show more
